Configuring Line Rate - H3C S5600 Series Operation Manual

Operation Manual – QoS-QoS Profile
H3C S5600 Series Ethernet Switches
III. Configuration example
# Assume GigabitEthernet 1/0/1 of the switch is connected to the 10.1.1.0/24 network
segment. Perform traffic policing on the packets from the 10.1.1.0/24 network segment,
setting the rate to 128 kbps. Mark the DSCP precedence as 56 for the inbound packets
exceeding the rate limit.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface GigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1] traffic-limit inbound ip-group 2000 128 exceed
remark-dscp 56

1.4.6 Configuring Line Rate

Refer to section
I. Configuration prerequisites
The port on which line rate configuration is to be performed has been determined.
The target rate has been determined.
II. Configuration procedure
Follow these steps to configure line rate:
Enter system view
Enter Ethernet port view
Configure line rate
III. Configuration example
# Set the line rate to 1024 kbps for outbound packets on GigabitEthernet 1/0/1.
<Sysname> system-view
Line Rate for information about line rate.
To do...
system-view
interface interface-type
interface-number
line-rate outbound
target-rate [ burst-bucket
burst-bucket-size ]
Use the command...
1-21
Chapter 1 QoS Configuration
Remarks
—
—
Required
Specify a committed
information rate (CIR) for
the target-rate argument,
and specify a committed
bust size (CBS) for the
burst-bucket-size
argument.
By default, line rate is
disabled.