Configuring Basic Rip Functions - H3C S5600 Series Operation Manual

Operation Manual – Routing Protocol
H3C S5600 Series Ethernet Switches
Configuring the network layer addresses of interfaces so that adjacent nodes are
reachable to each other at the network layer

3.3.2 Configuring Basic RIP Functions

I. Enabling RIP on the interfaces attached to a specified network segment
Follow these steps to enable RIP on the interfaces attached to a specified network
segment:
Enter system view
Enable RIP and enter RIP view
Enable RIP on the specified
interface
Note:
Related RIP commands configured in interface view can take effect only after RIP
is enabled.
RIP operates on the interfaces attached to a specified network segment. When
RIP is disabled on an interface, it does not operate on the interface, that is, it
neither receives/sends routes on the interface, nor forwards any interface route.
Therefore, after RIP is enabled globally, you must also specify its operating
network segments to enable it on the corresponding interfaces.
II. Setting the RIP operating status on an interface
Follow these steps to set the RIP operating status on an interface:
Enter system view
Enter interface view
Enable the interface to receive RIP
update packets
Enable the interface to send RIP
update packets
Enable the interface to receive and
send RIP update packets
To do...
To do...
3-4
Use the command...
system-view
rip
network
network-address
Use the command...
system-view
interface interface-type
interface-number
rip input
rip output
rip work
Chapter 3 RIP Configuration
Remarks
—
Required
Required
Disabled by default
Remarks
—
—
Optional
Enabled by
default