H3C S5600 Series Operation Manual page 1060

Operation Manual – FTP-SFTP-TFTP
H3C S5600 Series Ethernet Switches
Follow these steps to configure connection idle time:
Enter system view
Configure the connection idle
time for the FTP server
IV. Specifying the source interface and source IP address for an FTP server
You can specify the source interface and source IP address for an FTP server to
enhance server security. After this configuration, FTP clients can access this server
only through the IP address of the specified interface or the specified IP address.
Note:
Source interface refers to the existing VLAN interface or Loopback interface on the
device. Source IP address refers to the IP address configured for the interface on the
device. Each source interface corresponds to a source IP address. Therefore,
specifying a source interface for the FTP server is the same as specifying the IP
address of this interface as the source IP address.
Follow these steps to specify the source interface and source IP address for an FTP
server:
Enter system view
Specify the source
interface for an FTP
server
Specifying the source IP
address for an FTP server
To do...
To do...
system-view
ftp-server source-interface
interface-type
interface-number
ftp-server source-ip
ip-address
Chapter 1 FTP and SFTP Configuration
Use the command...
system-view
ftp timeout minutes
Use the command...
1-5
Remarks
—
Optional
30 minutes by default
Remarks
—
Use either command
Not specified by
default.