Operation Manual – PoE-PoE Profile
H3C S5600 Series Ethernet Switches
After the PoE feature is enabled, perform the following configuration to enable the PD
compatibility detection function.
Follow these steps to configure the PD compatibility detection function:
Enter system view
Enable the PD
compatibility detection
function
1.2.7 Configuring PoE Over-Temperature Protection on the Switch
If this function is enabled, the switch disables the PoE feature on all ports when its
internal temperature exceeds 65°C (149°F) for self-protection, and restores the PoE
feature settings on all its ports when the temperature drops below 60°C (140°F).
Follow these steps to configure PoE over-temperature protection on the switch:
Enter system view
Enable PoE
over-temperature
protection on the switch
Note:
When the internal temperature of the switch decreases from X (X>65°C, or X>149°F)
to Y (60°C≤Y<65°C, or 140°F≤Y<149°F), the switch still keeps the PoE function
disabled on all the ports.
When the internal temperature of the switch increases from X (X<60°C, or X<140°F)
to Y (60°C<Y≤65°C, or 140°F<Y≤149°F), the switch still keeps the PoE function
enabled on all the ports.
1.2.8 Upgrading the PSE Processing Software Online
The online upgrading of PSE processing software can update the processing software
or repair the software if it is damaged. Before performing the following configuration,
download the PSE processing software to the Flash of the switch.
Follow these steps to upgrade PSE processing software online:
To do...
system-view
poe legacy enable
To do...
system-view
poe
temperature-protection
enable
Use the command...
Use the command...
1-6
Chapter 1 PoE Configuration
Remarks
—
Required
Disabled by default.
Remarks
—
Optional
Enabled by default.