H3C S5600 Series Operation Manual page 1068

Operation Manual – FTP-SFTP-TFTP
H3C S5600 Series Ethernet Switches
C:\> ftp 1.1.1.1
Connected to 1.1.1.1.
220 FTP service ready.
User (1.1.1.1:(none)): switch
331 Password required for switch.
Password:
230 User logged in.
ftp>
# Upload file switch.bin.
ftp> put switch.bin
200 Port command okay.
150 Opening ASCII mode data connection for switch.bin.
226 Transfer complete.
ftp: 75980 bytes received in 5.55 seconds 13.70Kbytes/sec.
# Download file config.cfg.
ftp> get config.cfg
200 Port command okay.
150 Opening ASCII mode data connection for config.cfg.
226 Transfer complete.
ftp: 3980 bytes received in 8.277 seconds 0.48Kbytes/sec.
This example uses the command line window tool provided by Windows. When you log
in to the FTP server through another FTP client, refer to the corresponding instructions
for operation description.
Caution:
If available space on the Flash memory of the switch is not enough to hold the file to
be uploaded, you need to delete files not in use from the Flash memory to make
room for the file, and then upload the file again. The files in use cannot be deleted. If
you have to delete the files in use to make room for the file to be uploaded, you can
only delete/download them through the Boot ROM menu.
H3C series switch is not shipped with FTP client application software. You need to
purchase and install it by yourself.
3) Configure Switch A (FTP server)
# After uploading the application, use the boot boot-loader command to specify the
uploaded file (switch.bin) to be the startup file used when the switch starts the next
time, and restart the switch. Thus the switch application is upgraded.
Chapter 1 FTP and SFTP Configuration
1-13