Igmp Snooping Configuration Examples; Configuring Igmp Snooping - H3C S5600 Series Operation Manual

Operation Manual – Multicast
H3C S5600 Series Ethernet Switches

6.4 IGMP Snooping Configuration Examples

6.4.1 Configuring IGMP Snooping

I. Network requirements
To prevent multicast traffic from being flooded at Layer 2, enable IGMP snooping on
Layer 2 switches.
As shown in
GigabitEthernet 1/0/2, and to Switch A through GigabitEthernet 1/0/1.
Run PIM-DM and IGMP on Router A. Run IGMP snooping on Switch A. Router A
acts as the IGMP querier.
The multicast source sends multicast data to the multicast group 224.1.1.1. Host A
and Host B are receivers of the multicast group 224.1.1.1.
II. Network diagram
Source
1.1.1.1/24
Figure 6-3 Network diagram for IGMP Snooping configuration
III. Configuration procedure
1) Configure the IP address of each interface
Configure an IP address and subnet mask for each interface as per
detailed configuration steps are omitted.
2) Configure Router A
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 1/0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 1/0/1
Figure 6-3, Router A connects to a multicast source (Source) through
GE1/0/2 GE1/0/1
1.1.1.2/24 10.1.1.1/24
Router A
IGMP querier
Multicast packets
Chapter 6 IGMP Snooping Configuration
Receiver
Host A
VLAN100
GE1/0/4
GE1/0/1 GE1/0/3
Switch A
GE1/0/2
Host C
6-19
Receiver
Host B
Figure 6-3. The