Configuring A Static Ipv6 Route; Configuring Ipv6 Tcp Properties - H3C S5600 Series Operation Manual

Operation Manual – IPv6 Management
H3C S5600 Series Ethernet Switches
Configure the neighbor
reachable timeout time

1.2.3 Configuring a Static IPv6 Route

You can configure static IPv6 routes for network interconnection in a small sized IPv6
network.
Follow these steps to configure a static IPv6 route:
Enter system view
Configure a static IPv6
route

1.2.4 Configuring IPv6 TCP Properties

The IPv6 TCP properties you can configure include:
synwait timer: When a SYN packet is sent, the synwait timer is triggered. If no
response packet is received before the synwait timer expires, the IPv6 TCP
connection establishment fails.
finwait timer: When the IPv6 TCP connection status is FIN_WAIT_2, the finwait
timer is triggered. If no packet is received before the finwait timer expires, the IPv6
TCP connection is terminated. If FIN packets are received, the IPv6 TCP
connection status becomes TIME_WAIT. If other packets are received, the finwait
timer is reset from the last packet and the connection is terminated after the finwait
timer expires.
Size of IPv6 TCP receiving/sending buffer.
Follow these steps to configure IPv6 TCP properties:
Enter system view
Set the finwait timer of
IPv6 TCP packets
Set the synwait timer of
IPv6 TCP packets
To do...
ipv6 nd nud
reachable-time value
To do...
system-view
ipv6 route-static
ipv6-address prefix-length
[ interface-type
interface-number]
nexthop-address
To do...
system-view
tcp ipv6 timer
fin-timeout wait-time
tcp ipv6 timer
syn-timeout wait-time
Use the command...
Use the command...
Use the command...
1-16
Chapter 1 IPv6 Configuration
Remarks
Optional
30,000 milliseconds by
default.
Remarks
—
Required
By default, no static IPv6
route is configured.
Remarks
—
Optional
675 seconds by default.
Optional
75 seconds by default.