H3C S5600 Series Operation Manual page 1102

Operation Manual – Information Center
H3C S5600 Series Ethernet Switches
Enable system
information output to a log
host
Configure the source
interface through which
log information is sent to
the log host
Configure the output rules
of system information
Set the format of the time
stamp to be sent to the log
host
Note:
After the switches form a fabric, you can use the info-center switch-on command
to enable the information output for the switches to make the log, debugging and
trap information of each switch in the fabric synchronous. Each switch sends its own
information to other switches in the fabric and receives information sent by other
switches at the same time to update the information on itself. In this way, the switch
ensures the synchronization of log, debugging and trap information in the whole
fabric.
Be sure to set the correct IP address when using the info-center loghost command.
A loopback IP address will cause an error message prompting that this address is
invalid.
To do...
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
info-center loghost
source interface-type
interface-number
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
info-center timestamp
loghost { date |
no-year-date | none }
Use the command...
1-15
Chapter 1 Information Center
Remarks
Required
By default, the switch
does not output
information to the log
host.
After you configure the
switch to output
information to the log
host, the switch uses
information channel 2 by
default.
Optional
By default, no source
interface is configured,
and the system
automatically selects an
interface as the source
interface.
Optional
Refer to Table 1-4 for the
default output rules of
system information.
Optional
By default, the time stamp
format of the information
output to the log host is
date.