Displaying And Maintaining Irf Fabric - H3C S5600 Series Operation Manual

Operation Manual – IRF Fabric
H3C S5600 Series Ethernet Switches
II. Configuration procedure
Follow these steps to configure IRF automatic fabric for a switch:
Enter system view
Configure IRF automatic
fabric for a switch
Caution:
You need to enable the IRF automatic fabric function on all the devices including the
newly added device in the fabric to enable the newly added device to download
software and discovery neighbors and thus be added to the fabric normally.
After you configure the IRF automatic fabric function on Slave, execute the save
command to save the configurations as soon as possible. Otherwise, the device
may synchronize the configurations from Master and restart repeatedly because the
configurations on the device are lost after the device automatically downloads the
software and restarts.
Note:
When fabric works normally, you can configure the whole fabric as an individual device.
As a fabric is comprised of multiple devices, busy working state may occur due to data
transmission between devices or synchronous execution of programs. When you
perform an operation, if you receive a prompt "Fabric system is busy, please try later...",
which indicates that the fabric does not execute your configuration properly, you need
to verify your configuration or reconfigure the previous operation.

1.3 Displaying and Maintaining IRF Fabric

Display the information
about an IRF fabric
Display the topology
information of an IRF fabric
Clear the FTM statistics
To do...
system-view
fabric
member-auto-update
software enable
To do...
Use the command...
Use the command...
display irf-fabric [ status ]
display ftm { information |
topology-database }
reset ftm statistics
1-10
Chapter 1 IRF Fabric Configuration
Remarks
—
Required
Disabled by default
Remarks
Available in any view
Available in user view