H3C S5600 Series Operation Manual page 290

Operation Manual – MSTP
H3C S5600 Series Ethernet Switches
parameter. It depends on the physical state of the port and network structure. You can
configure this parameter according to the network.
I. Configure the maximum transmitting rate for specified ports in system view
Follow these steps to configure the maximum transmitting rate for specified ports in
system view:
Enter system view
Configure the maximum
transmitting rate for
specified ports
II. Configure the maximum transmitting rate in Ethernet port view
Follow these steps to configure the maximum transmitting rate in Ethernet port view:
Enter system view
Enter Ethernet port view
Configure the maximum
transmitting rate
As the maximum transmitting rate parameter determines the number of the
configuration BPDUs transmitted in each hello time, set it to a proper value to prevent
MSTP from occupying too many network resources. The default value is
recommended.
III. Configuration example
# Set the maximum transmitting rate of GigabitEthernet 1/0/1 to 15.
1) Configure the maximum transmitting rate in system view
<Sysname> system-view
[Sysname] stp interface GigabitEthernet 1/0/1 transmit-limit 15
2) Configure the maximum transmitting rate in Ethernet port view
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp transmit-limit 15
To do...
system-view
stp interface interface-list
transmit-limit packetnum
To do...
system-view
interface interface-type
interface-number
stp transmit-limit
packetnum
Use the command...
Use the command...
1-31
Chapter 1 MSTP Configuration
Remarks
—
Required
The maximum
transmitting rate of all
Ethernet ports on a switch
defaults to 10.
Remarks
—
—
Required
The maximum
transmitting rate of all
Ethernet ports on a switch
defaults to 10.