H3C S5600 Series Operation Manual page 875

Operation Manual – Mirroring
H3C S5600 Series Ethernet Switches
Layer 2 connectivity is ensured between the source and destination switches over
the remote-probe VLAN.
2) Configuration procedure
Follow these steps to configure remote port mirroring on the destination switch:
Enter system view
Create a VLAN and enter
VLAN view
Configure the current
VLAN as a remote-probe
VLAN
Return to system view
Enter the view of the
Ethernet port connecting
to the source switch or an
intermediate switch
Configure the current port
as trunk port
Configure trunk port to
permit packets from the
remote-probe VLAN
Return to system view
Create a remote
destination mirroring
group
Configure the destination
port for the remote
destination mirroring
group
Configure the
remote-probe VLAN for
the remote destination
mirroring group
When configuring a destination switch, note that:
An S5600 series Ethernet switch acting as the destination switch in remote port
mirroring networking does not support bidirectional packet mirroring (the both
keyword).
The destination port of remote port mirroring cannot be a member port of an
existing mirroring group, a fabric port, a member port of an aggregation group, or a
port enabled with LACP or STP.
To do...
system-view
vlan vlan-id
remote-probe vlan
enable
quit
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
remote-probe-vlan-id
quit
mirroring-group group-id
remote-destination
mirroring-group group-id
monitor-port
monitor-port
mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
Use the command...
1-8
Chapter 1 Mirroring Configuration
Remarks
—
vlan-id is the ID of the
remote-probe VLAN.
Required
—
—
Required
By default, the port type is
Access.
Required
—
Required
Required
Required