Operation Manual – Multicast
H3C S5600 Series Ethernet Switches
Enter system view
Enable multicast routing
Enter interface view
Enable PIM-DM
4.3 Configuring PIM-SM
Complete the following tasks to configure PIM-SM:
Enabling PIM-SM
Configuring an RP
Configuring a BSR
Filtering the Registration Packets from DR to RP
Disabling RPT-to-SPT Switchover
4.3.1 Enabling PIM-SM
With PIM-SM enabled, a router sends hello messages periodically to discover PIM
neighbors and processes messages from PIM neighbors. When deploying a PIM-SM
domain, you are recommended to enable PIM-SM on all interfaces of non-border
routers (border routers are PIM-enabled routers located on the boundary of BSR
admin-scope regions).
Follow these steps to enable PIM-SM:
Enter system view
Enable multicast routing
Enter interface view
Enable PIM-SM
To do...
system-view
multicast
routing-enable
interface interface-type
interface-number
pim dm
Task
To do...
system-view
multicast
routing-enable
interface interface-type
interface-number
pim sm
Use the command...
Use the command...
4-12
Chapter 4 PIM Configuration
Remarks
—
Required
Disabled by default
—
Required
Disabled by default
Remarks
Required
Required
Optional
Optional
Optional
Remarks
—
Required
Disabled by default
—
Required
Disabled by default