H3C S5600 Series Operation Manual page 950

Operation Manual – SNMP-RMON
H3C S5600 Series Ethernet Switches
Enter system view
Enable SNMP agent
Set system information, and
specify to enable SNMPv1 or
SNMPv2c on the switch
Set a
communi
ty name
and
access
permissi
on
Set the maximum size of an
SNMP packet for SNMP agent
to receive or send
Set the device engine ID
To do...
Direct Set a
configu commun
ration ity name
Set an
SNMP
group
Indirect
configu
ration
Add a
user to
an
SNMP
group
Use the command...
system-view
snmp-agent
snmp-agent sys-info
{ contact sys-contact |
location sys-location |
version { { v1 | v2c | v3
}* | all } }
snmp-agent
community { read |
write } community-name
[ acl acl-number |
mib-view view-name ]*
snmp-agent group { v1
| v2c } group-name
[ read-view read-view ]
[ write-view write-view ]
[ notify-view
notify-view ] [ acl
acl-number ]
snmp-agent usm-user
{ v1 | v2c } user-name
group-name [ acl
acl-number ]
snmp-agent packet
max-size byte-count
snmp-agent
local-engineid engineid
1-4
Chapter 1 SNMP Configuration
Remarks
—
Optional
Disabled by default.
You can enable SNMP
agent by executing
this command or any
of the commands
used to configure
SNMP agent.
Required
By default, the contact
information for system
maintenance is
"Hangzhou H3C
Technologies Co.,
Ltd.", the system
location is "Hangzhou
China", and the SNMP
version is SNMPv3.
Required
You can set an
SNMPv1/SNMPv2
c community name
through
configuration.
Indirect
configuration
compatible
SNMPv3.
added user
equal to
community
for SNMPv1 and
SNMPv2c.
You can choose
either of them as
needed.
Optional
1,500 bytes by
default.
Optional
By default, the device
engine ID is
"enterprise number +
device information".
direct
is
with
The
is
the
name