H3C S5600 Series Operation Manual page 907

Operation Manual – Cluster
H3C S5600 Series Ethernet Switches
Enter system view
Configure the holdtime of
NDP information
Configure the interval to
send NDP packets
IV. Enabling NTDP globally and on a specific port
Follow these steps to enable NTDP globally and on a specific port:
Enter system view
Enable NTDP globally
Enter Ethernet port view
Enable NTDP on the
Ethernet port
V. Configuring NTDP-related parameters
Follow these steps to configure NTDP-related parameters:
Enter system view
Configure the range to
collect topology
information
Configure the device
forward delay of topology
collection requests
Configure the port forward
delay of topology
collection requests
To do...
system-view
ndp timer aging
aging-in-seconds
ndp timer hello seconds
To do...
system-view
ntdp enable
interface interface-type
interface-number
ntdp enable
To do...
system-view
ntdp hop hop-value
ntdp timer hop-delay
time
ntdp timer port-delay
time
Use the command...
Use the command...
Use the command...
1-13
Chapter 1 Cluster
Remarks
—
Optional
By default, the holdtime of
NDP information is 180
seconds.
Optional
By default, the interval to
send NDP packets is 60
seconds.
Remarks
—
Required
Enabled by default
—
Required
Enabled by default
Remarks
—
Optional
By default, the system
collects topology
information from the
devices within three hops.
Optional
By default, the device
forward delay is 200 ms.
Optional
By default, the port
forward delay is 20 ms.