Displaying Snmp; Snmp Configuration Example - H3C S5600 Series Operation Manual

Operation Manual – SNMP-RMON
H3C S5600 Series Ethernet Switches

1.5 Displaying SNMP

Display the SNMP
information about the
current device
Display SNMP packet
statistics
Display the engine ID of
the current device
Display group information
about the device
Display SNMP user
information
Display trap list
information
Display the currently
configured community
name
Display the currently
configured MIB view

1.6 SNMP Configuration Example

1.6.1 SNMP Configuration Example
I. Network requirements
An NMS and Switch A (SNMP agent) are connected through the Ethernet. The IP
address of the NMS is 10.10.10.1 and that of the VLAN interface on Switch A is
10.10.10.2.
Perform the following configuration on Switch A: setting the community name and
access permission, administrator ID, contact and switch location, and enabling the
switch to sent traps.
Thus, the NMS is able to access Switch A and receive the traps sent by Switch A.
To do...
display snmp-agent sys-info
[ contact | location | version ]*
display snmp-agent statistics
display snmp-agent {
local-engineid | remote-engineid }
display snmp-agent group
[ group-name ]
display snmp-agent usm-user
[ engineid engineid | username
user-name | group group-name ]*
display snmp-agent trap-list
display snmp-agent community
[ read | write ]
display snmp-agent mib-view
[ exclude | include | viewname
view-name ]
Use the command...
1-9
Chapter 1 SNMP Configuration
Remarks
Available in
any view.