H3C S5600 Series Operation Manual page 1121

Hide thumbs Also See for H3C S5600 Series:

Table of Contents

Operation Manual – System Maintenance and Debugging

H3C S5600 Series Ethernet Switches

Step 4: Enter 1 in the above menu to download the Boot ROM using TFTP. Then set the

following TFTP-related parameters as required:

Load File name

Switch IP address

Server IP address

Step 5: Press <Enter>. The system displays the following information:

Are you sure to update your bootrom?Yes or No(Y/N)

Step 6: Enter Y to start file downloading or N to return to the Boot ROM update menu. If

you enter Y, the system begins to download and update the Boot ROM. Upon

completion, the system displays the following information:

Loading........................................done

Bootrom updating..........done!

III. Loading host software

Follow these steps to load the host software.

Step 1: Select <1> in BOOT Menu and press <Enter>. The system displays the

following information:

1. Set TFTP protocol parameter

2. Set FTP protocol parameter

3. Set XMODEM protocol parameter

0. Return to boot menu

Enter your choice(0-3):

Step 2: Enter 1 in the above menu to download the host software using TFTP.

The subsequent steps are the same as those for loading the Boot ROM, except that the

system gives the prompt for host software loading instead of Boot ROM loading.

When loading Boot ROM and host software using TFTP through BOOT menu, you are

recommended to use the PC directly connected to the device as TFTP server to

promote upgrading reliability.

Chapter 1 Boot ROM and Host Software

Chapters

Table of Contents