H3C S5600 Series Operation Manual page 873

Operation Manual – Mirroring
H3C S5600 Series Ethernet Switches
Follow these steps to perform configurations on the source switch:
Enter system view
Create a VLAN and enter
the VLAN view
Configure the current
VLAN as the
remote-probe VLAN
Return to system view
Enter the view of the
Ethernet port that
connects to the
intermediate switch or
destination switch
Configure the current port
as trunk port
Configure the trunk port to
permit packets from the
remote-probe VLAN
Return to system view
Create a remote source
mirroring group
Configure source port(s)
for the remote source
mirroring group
Configure the reflector
port for the remote source
mirroring group
Configure the
remote-probe VLAN for
the remote source
mirroring group
When configuring the source switch, note that:
All ports of a remote source mirroring group are on the same device. Each remote
source mirroring group can be configured with only one reflector port.
The reflector port cannot be a member port of an existing mirroring group, a fabric
port, a member port of an aggregation group, or a port enabled with LACP or STP.
It must be an access port and cannot be configured with functions like VLAN-VPN,
port loopback detection, packet filtering, QoS, port security, and so on.
You cannot modify the duplex mode, port rate, and MDI attribute of a reflector port.
To do...
system-view
vlan vlan-id
remote-probe vlan
enable
quit
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
remote-probe-vlan-id
quit
mirroring-group group-id
remote-source
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
mirroring-group group-id
reflector-port
reflector-port
mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
Use the command...
1-6
Chapter 1 Mirroring Configuration
Remarks
—
vlan-id is the ID of the
remote-probe VLAN.
Required
—
—
Required
By default, the port type is
Access.
Required
—
Required
Required
Required
Required