Displaying And Maintaining Rip Configuration - H3C S5600 Series Operation Manual

Operation Manual – Routing Protocol
H3C S5600 Series Ethernet Switches
IV. Setting RIP-2 packet authentication mode
RIP-2 supports two authentication modes: simple authentication and message digest
5 (MD5) authentication.
Simple authentication cannot provide complete security, because the authentication
keys sent along with packets that are not encrypted. Therefore, simple authentication
cannot be applied where high security is required.
Follow these steps to set RIP-2 packet authentication mode:
To do...
Enter system
view
Enter interface
view
Set RIP-2
packet
authentication
mode
V. Configuring RIP to unicast RIP packets
Follow these steps to configure RIP to unicast RIP packets:
To do...
Enter system view
Enter RIP view
Configure RIP to
unicast RIP packets

3.6 Displaying and Maintaining RIP Configuration

Display the current RIP running status
and configuration information
Display RIP interface information
Use the command...
system-view
interface interface-type
interface-number
rip
authentication-mode
{ simple password |
md5 { rfc2082 key-string
key-id | rfc2453
key-string } }
Use the
command...
system-view
rip
peer ip-address
To do...
3-11
Chapter 3 RIP Configuration
Remarks
—
—
Required
If you specify to use MD5
authentication, you must specify one of
the following MD5 authentication types:
rfc2453 (this type supports the
packet format defined in RFC 2453)
rfc2082 (this type supports the
packet format defined in RFC 2082)
Remarks
—
—
Required
When RIP runs on the link that does not
support broadcast or multicast, you must
configure RIP to unicast RIP packets.
Use the command...
display rip
display rip interface
Remarks
Available in
any view