H3C S5600 Series Operation Manual page 1128

Operation Manual – System Maintenance and Debugging
H3C S5600 Series Ethernet Switches
Figure 1-13 Upload file switch.btm to the switch
Step 8: Configure switch.btm to be the Boot ROM at next startup, and then restart the
switch.
<Sysname> boot bootrom switch.btm
This will update Bootrom on unit 1.
Upgrading Bootrom, please wait...
Upgrade Bootrom succeeded!
<Sysname> reboot
After the switch restarts, the file switch.btm is used as the Boot ROM. It indicates that
the Boot ROM loading is finished.
2) Loading host software
Loading the host software is the same as loading the Boot ROM program, except that
the file to be downloaded is the host software file, and that you need to use the boot
boot-loader command to select the host software used for the next startup of the
switch.
Chapter 1 Boot ROM and Host Software
Continue? [Y/N] y
1-17
Loading