Configuration - Polycom IP 320 Administrator's Manual

Configuration

Warning
Note
The SoundPoint IP / SoundStation IP / VVX phones can be configured
automatically through files stored on a central provisioning server, manually
through the phone's local UI or web interface, or by using a combination of the
automatic and manual methods.
The recommended method for configuring phones is automatically through a
central provisioning server, but if one is not available, the manual method will
allow changes to most of the key settings.
Configuration files should only be modified by a knowledgeable system
administrator. Applying incorrect parameters may render the phone unusable. The
configuration files which accompany a specific release of the SIP software must be
used together with that software. Failure to do this may render the phone unusable.
You can make changes to the configuration files through the web interface to the
phone. Using your chosen browser, enter the phone's IP address as the browser
address. For more information, refer to
Web Interface on page C-27.
Changes made through the web interface are written to the override file (highest
priority). These changes remain active and will take precedence over the
configuration files stored on the provisioning server until Reset Local Config is
performed.
The phone configuration files consist of:
• Master Configuration Files
• Application Configuration Files
• Override Files
This section also contains information on:
• Central Provisioning
• Manual Configuration
Master Configuration Files
The master configuration files can be one of:
• Specified master configuration file
• Per-phone master configuration file
• Default master configuration file
For more information, refer to
Modifying Phone's Configuration Using the
Master Configuration Files
Overview
on page A-2.
2 - 5