Polycom IP 320 Administrator's Manual page 202

Administrator's Guide for the SoundPoint IP / SoundStation IP / VVX Family
Attribute
voIpProt.SIP.compliance.RFC3261.
validate.contentLanguage
voIpProt.SIP.compliance.RFC3261.
validate.uriScheme
Note
Attribute
voIpProt.H323.enable
voIpProt.H323.local.port
voIpProt.H323.
autoGatekeeperDiscovery
voIpProt.H323.dtmfViaSignaling.
enabled
A - 22
Compliance <compliance/>
This configuration attribute is defined as follows:
Permitted
Values
0 or 1
0 or 1
H.323 <H323/>
At this time, this attribute is used with the Polycom VVX 1500 phone only.
This configuration attribute is defined as follows:
Permitted
Values
0 or 1
0 to 65535
0 or 1
0 or 1
Default Interpretation
Null If set to 1, validation of the SIP header
content language is enabled.
If set to 0 or Null, validation is disabled.
Null If set to 1 or Null, validation of the SIP header
URI scheme is enabled.
If set to 0, validation is disabled.
Default Interpretation
0 Flag to determine whether or not the H.323
protocol is used for call routing, dial plan,
DTMF, and URL dialing.
If set to 1, the H.323 protocol is used.
1720 Local port to be used for H.323 signaling.
Local port for sending and receiving H.323
signaling packets.
If set to 0 or Null, 1720 is used for the local
port but it is not advertised in the H.323
signaling.
If set to some other value, that value is used
for the local port and it is advertised in the
H.323 signaling.
0 If set to 1, the phone will attempt to discover
an H.323 gatekeeper address via the
standard multicast technique, provided that a
statically configured gatekeeper address is
not available.
If set to 0, the phone will no send out any
gatekeeper discovery messages.
1 If set to 1, the phone will use the H.323
signaling channel for DTMF key press
transmission.