Setting Up The Provisioning Server - Polycom IP 320 Administrator's Manual

Administrator's Guide for the SoundPoint IP / SoundStation IP / VVX Family
Name
Server Address
Server Type
Facility
Render Level
Prepend MAC
Address

Setting Up the Provisioning Server

3 - 14
The following syslog configuration parameters can be modified on the Syslog
menu:
Possible Values
dotted-decimal IP address
OR
domain name string
None=0,
UDP=1,
TCP=2,
TLS=3
0 to 23
0 to 6
Enabled, Disabled
The provisioning server can be on the local LAN or anywhere on the Internet.
Multiple provisioning servers can be configured by having the provisioning
server DNS name map to multiple IP addresses. The default number of
provisioning servers is one and the maximum number is eight. The following
protocols are supported for redundant provisioning servers: HTTPS, HTTP,
and FTP. For more information on the protocol used on each platform, refer to
Supported Provisioning Protocols
All of the provisioning servers must be reachable by the same protocol and the
content available on them must be identical. The parameters described in
section Server Menu
each server will be tried for a file transfer and also how long to wait between
each attempt. The maximum number of servers to be tried is configurable. For
more information, contact your Certified Polycom Reseller.
Description
The syslog server IP address or host name.
The default value is NULL.
The protocol that the phone will use to write to the syslog
server.
If set to "None", transmission is turned off, but the server
address is preserved.
A description of what generated the log message. For
more information, refer to section 4.1.1 of RFC 3164.
The default value is 16, which maps to "local 0".
Specifies the lowest class of event that will be rendered to
syslog. It is based on log.render.level and can be a
lower value.
Refer to Basic Logging <level/><change/> and <render/>
on page A-106.
Note: Use left and right arrow keys to change values.
If enabled, the phone's MAC address is prepended to the
log message sent to the syslog server.
on page 3-4.
on page 3-10 can be used to configure the number of times