Polycom IP 320 Administrator's Manual page 206

Polycom soundpoint ip/soundstation ip/ vvx family
Hide thumbs Also See for IP 320:
Table of Contents

Advertisement

Administrator's Guide for the SoundPoint IP / SoundStation IP / VVX Family
Attribute
dialplan.digitmap
dialplan.digitmap.timeOut
A - 26
If a digit map does not comply, it is not included in the digit plan as a valid
one. That is, no matching is done against it.
There is no limitation on the number of R triplet sets in a digit map.
However, a digit map that contains less than full number of triplet sets (for
example, a total of 2Rs or 5Rs) is considered an invalid digit map.
Using T in the left part of RRR syntax is not recommended. For example,
R0TR322R should be avoided.
This configuration attribute is defined as follows:
Permitted Values
string compatible with the
digit map feature of
MGCP described in 2.1.5
of RFC 3435. String is
limited to 768 bytes and
30 segments; a comma is
also allowed; when
reached in the digit map,
a comma will turn dial
tone back on;'+' is allowed
as a valid digit; extension
letter 'R' is used as
defined above.
string of positive integers
separated by '|'
Routing <routing/>
This attribute allows the user to create a specific routing path for outgoing SIP
calls independent of other "default" configurations.
This attribute also includes:
Server <server/>
Default
Interpretation
[2-9]11|0T|
When this attribute is
present, number-only dialing
+011xxx.T|
during the setup phase of
0[2-9]xxxxxxxxx|
new calls will be compared
+1[2-9]xxxxxxxx|
against the patterns therein
and if a match is found, the
[2-9]xxxxxxxxx|
call will be initiated
[2-9]xxxT
automatically eliminating the
need to press Send.
Attributes
dialplan.applyToCallLis
tDial,
dialplan.applyToDirecto
ryDial,
dialplan.applyToUserDia
l, and
dialplan.applyToUserSen
d control the use of match
and replace in the dialed
number in the different
scenarios.
3 | 3 | 3 | 3 | 3 | 3
Timeout in seconds for each
segment of digit map.
Note: If there are more digit
maps than timeout values,
the default value of 3 will be
used. If there are more
timeout values than digit
maps, the extra timeout
values are ignored.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents