Polycom IP 320 Administrator's Manual page 161

Local Web Point your web browser to http://<phoneIPAddress>/.
Server Access
Configuration pages are accessible from the menu along the top banner.
The web server will issue an authentication challenge to all pages except for
the home page.
Credentials are (case sensitive):
User Name: Polycom
Password: The administrator password is used for this.
Local Settings Some items in the Settings menu are locked to prevent accidental changes.
Menu Access To unlock these menus, enter the user or administrator passwords.
The administrator password can be used anywhere that the user password is
used. (Polycom recommends that you change the administrative password
from the default value.)
Factory default passwords are:
User password: 123
Administrator password: 456
Passwords:
Administrator Network Configuration
password Line Configuration
required. Call Server Configuration
SSL Security settings
Reset to Default - local configuration, device settings, and file system format
User password Reboot Phone
required.
Changes made through the web server or local user interface are stored
internally as overrides. These overrides take precedence over settings
contained in the configuration obtained from the provisioning server.
If the provisioning server permits uploads, these override setting will be saved
in a file called <Ethernet address>-phone.cfg on the provisioning server as
well as in flash memory.
Warning Local configuration changes will continue to override the provisioning
server-derived configuration until deleted through the Reset Local Config menu
selection or configured using the 'device set ' procedure.
For more information, refer to
Web Interface
Modifying Phone's Configuration Using the
on page C-27.
Configuring Your System
4 - 99