Polycom IP 320 Administrator's Manual page 213

Attribute
up.mwiVisible
up.handsfreeMode
up.numberFirst CID
up.idleBrowser.enabled
up.prioritizeBackgroundMenuItem
.enable
up.screenCapture.enabled
up.manualProtocolRouting
Permitted
Values Default
0 or 1 0
0 or 1 1
0 or 1 0
0 or 1 Null
0 or 1 1
0 or 1 0
0 or 1 1
Interpretation
If set is 0 or Null, the incoming MWI
notifications for lines where the MWI callback
mode is disabled (msg.mwi.x.callBackMode
is set to 0) are ignored, and do not appear in
the message retrieval menus.
If set to 1, the MWI for lines whose MWI is
disabled is displayed (pre-SIP 2.1 behavior),
even though MWI notifications have been
received for those lines.
If set to 1 or Null, hands-free speakerphone is
enabled.
If set to 0, hands-free speakerphone is
disabled.
If set to 0 or Null, caller ID display will show
caller's name first.
If set to 1, caller ID display will show caller's
number first.
A flag to determine whether or not the
background takes priority over the idle
browser. Used in conjunction with
up.prioritizeBackground.enable .
If set to 1, the "Prioritize Background" menu is
available to the user. The user can then decide
whether or not the background takes priority
over the idle browser. Used in conjunction with
up.idleBrowser.enabled .
A flag to determine whether or not the user
can get a screen capture of the current screen
shown on a phone. The flag is cleared when
the phone reboots.
If set to 1, the "Screen Capture" menu is
available to the user.
Refer to Capturing Phone's Current Screen
page C-30.
If set to 1, the user is presented with protocol
routing choices when a call could be placed
with more than one protocol from its current
context. The user must choose between SIP
and H.323 to place a call.
Note: This parameter is supported on the
Polycom VVX 1500 only.
Configuration Files
on
A - 33