Quality Of Service <Qos - Polycom IP 320 Administrator's Manual

Attribute
video.camera.contrast
video.camera.sharpness
Attribute
video.localCameraView.
fullscreen.enabled
video.localCameraView.
fullscreen.mode
Quality of Service <QOS/>
Permitted
Values Default
0 to 4 Null
0 to 6 Null
Local Camera View <localCameraView/>
These settings control how the local camera is viewed on the screen.
These configuration attributes are defined as follows:
Permitted
Values Default
0=Disable, Null
1=Enable
"pip" or Null
Null
These settings control the Quality of Service (QOS) options.
This attribute includes:
• Ethernet IEEE 802.1p/Q <ethernet/>
• IP TOS <IP/>
Ethernet IEEE 802.1p/Q <ethernet/>
The following settings control the 802.1p/Q user_priority field:
• RTP <RTP/>
• Call Control <callControl/>
Interpretation
Set contrast level.
The value range is from 0 (No contrast increase) to
3 (Most contrast increase, and 4 (Noise reduction
contrast).
If set to Null, the value 0 is used.
Set sharpness level.
The value range is from 0 (Lowest) to 6 (Highest).
If set to Null, the value 3 is used.
Interpretation
Determines whether the local camera view is
shown in the full screen layout .
If set to 0, the local camera view is not shown.
If set to 1 or Null, the local camera view is shown.
How the local camera view is shown.
If set to "pip", the local camera view appears as a
picture-in-picture with the far end window.
If set to Null, the local camera view appears
side-by-side with the far end window.
Configuration Files
A - 71