Automatic Call Distribution <Acd - Polycom IP 320 Administrator's Manual

Administrator's Guide for the SoundPoint IP / SoundStation IP / VVX Family
Attribute
up.screenSaver.enabled
up.screenSaver.waitTime
Automatic Call Distribution <acd/>
Attribute
acd.reg
acd.stateAtSignIn
A - 156
Permitted
Values Default
0 or 1 0
1 to 9999 Null
This configuration attribute is defined as follows:
Permitted
Values Default
1 to 34 1
0 or 1 1
Interpretation
If set to 1, a USB flash drive is attached to the phone,
and the idle browser is not configured, a slide show
will cycle through the images from the USB flash
drive. The images must stored in the appropriate
directory of the USB flash drive
(up.pictureFrame.folder in phone1.cfg). The slide
show does not appear when the phone is in the active
state. If set to 1, but there is no USB flash drive
attached to the phone, there is not change on the
screen. However, the screen saver will start working
once a USB flash drive is attached.
If set to 0, the feature is disabled.
Note: This parameter is supported on the
Polycom VVX 1500 only.
Note: If the idle browser is also enabled, the idle
browser is displayed until the screen saver times out;
then the screen saver appears. When the screen
saver exits, the idle browser is displayed again and is
up to date (it is refreshed in the background).
The time to wait (In minutes) in the idle state (until the
screen saver starts).
If set to Null, the default time is 15 minutes.
Note: This parameter is supported on the
Polycom VVX 1500 only.
Interpretation
The registration index used to support BroadSoft
server-based ACD. If set to Null, line 1 is used.
The state of the user when signing in.
If set to 1 or Null, the user is available.
If set to 0, the user is unavailable.