Polycom IP 320 Administrator's Manual page 272

Administrator's Guide for the SoundPoint IP / SoundStation IP / VVX Family
SoundPoint IP 32x, 33x, 430, 450
"fontProp_10"
"fontPropSoftkey_10"
SoundPoint IP 550, 560, 650, and 670
"fontProp_19"
"fontProp_26"
"fontProp_x"
A - 92
font support for Unicode ranges not already embedded. The font file must be
a Microsoft .fnt file format. The font file name must follow a specific pattern as
described:
• Font filename:
<fontName>_<fontHeightInPixels>_<fontRange>.<fontExtension>
• <fontName> is a free string of characters that typically carries the meaning
of the font. Examples are "fontFixedSize" for a fixed-size font, or
"fontProportionalSize" for a proportional size font.
• <fontHeightInPixels> describes the font height in number of screen pixels.
• <fontRange> describes the Unicode range covered by this font. Since .fnt
are 256 characters based blocks, the <fontRange> is Uxx00_UxxFF (.fnt
file). For more information, refer to
4-29.
• <fontExtension> describes the file type. Either .fnt for single 256
characters font .
If it is necessary to overwrite an existing font, use these
<fontName>_<fontHeightInPixels>:
This is the font used widely in the current implementation.
This is the soft key specific font.
This is the font used widely in the current implementation including for
soft keys.
This is the font used to display time (but not date).
This is a small font used for the CPU/Load/Net utilization graphs, this
is the same as the "fontProp_10" for the SoundPoint IP 500.
If the <fontName>_<fontHeightInPixels> does not match any of the names
above, then the downloaded font will be applied against all fonts defined in
the phone, which means that you may lose the benefit of fonts being calibrated
differently depending on their usage. For example, the font used to display the
time on the SoundPoint IP 650 is a large font, larger than the one used to
display the date, and if you overwrite this default font with a unique font, you
lose this size aspect. For example:
• to overwrite the font used for SoundPoint IP 500 soft keys for ASCII, the
name should be fontPropSoftkey_10_U0000_U00FF.fnt .
• to add support for a new font that will be used everywhere and that is not
currently supported. For example, for the Eastern/Central European
Czech language, this is Unicode range 100-17F, the name could be
fontCzechIP500_10_U0100_U01FF.fnt and
fontCzechIP600_19_U0100_U01FF.fnt .
Multilingual User Interface on page