Enabling The Web Configuration Utility - Polycom VVX 201 User Manual

9. Click the Yes button when the pop-up message appears asking if you want to save the
configuration changes (Figure 3-22). The phone should reboot, provision and register. If it
does not reboot, proceed to step 10.
10. Go off-hook.
11. Press and hold the 0, 1 and 3 keys until the phone reboots.
12. Go on-hook.
NOTE: In this guide, off-hook is used to describe when a phone is in use or has a dial tone before
a call is made. On-hook describes when a phone is idle.
To determine if the phone is registered (which is necessary to make and receive calls), examine the
phone screen. It should display the extension on the left side of the screen along with a check mark
(Figure 3-23).

Enabling the Web Configuration Utility

When the device reprograms itself as a part of provisioning process, the web configuration utility
will be disabled. This is a default action done to protect your phone from outside influence. If the IP
address does not load the phone's web interface, follow the steps below to enable the web
configuration utility.
1. Press the HOME button on the upper-right of the phone.
Figure 3-22: Confirmation Window
Figure 3-23: Active Line
14 | P a g e
© Nextiva, All Rights Reserved