Polycom IP 320 Administrator's Manual page 309

Attribute
softkey.x.enable
softkey.x.precede
softkey.x.use.idle
softkey.x.use.active
softkey.x.use.alerting
softkey.x.use.dialtone
softkey.x.use.proceeding
softkey.x.use.setup
softkey.x.use.hold
softkey.feature.newcall
Permitted
Values Default
0 (default) Null
1
0 (default) Null
1
0 (default) Null
1
0 (default) Null
1
0 (default) Null
1
0 (default) Null
1
0 (default) Null
1
0 (default) Null
1
0 (default) Null
1
0 Null
1 (default)
Interpretation
If set to 0 or Null, the soft key is disabled.
If set to 1, the soft key is enabled.
If set to 0 or Null, the soft key replaces any
empty space from the leftmost position.
If set to 1, the soft key is displayed before
the first standard soft key.
If set to 0 or Null, the soft key is not
displayed in the idle state.
If set to 1, the soft key is displayed in the
idle state.
If set to 0 or Null, the soft key is not
displayed in the active call state.
If set to 1, the soft key is displayed in the
active call state.
If set to 0 or Null, the soft key is not
displayed in the alerting state.
If set to 1, the soft key is displayed in the
alerting state.
If set to 0 or Null, the soft key is not
displayed in the dialtone state.
If set to 1, the soft key is displayed in the
dialtone state.
If set to 0 or Null, the soft key is not
displayed in the proceeding state.
If set to 1, the soft key is displayed in the
proceeding state.
If set to 0 or Null, the soft key is not
displayed in the setup state.
If set to 1, the soft key is displayed in the
setup state.
If set to 0 or Null, the soft key is not
displayed in the hold state.
If set to 1, the soft key is displayed in the
hold state.
If set to 0, the New Call soft key is not
displayed when there is another way to
place a call.
If set to 1 or Null, the New Call soft key is
displayed.
Configuration Files
A - 129