Configuring Snmp Credentials - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

14. If you are configuring a 256-port director, select the Configure for 256-Port_Director_Name
FIGURE 21
15. Enter a user name in the User Name field.
16. Enter a context name In the Context Name field.
17. Select the authorization protocol in the Auth Protocol field.
18. Enter the authorization password in the Auth Password field.
19. Select the privacy protocol in the Priv Protocol field.
20. Enter the privacy password in the Priv Password field.
21. Click OK on the Address Properties dialog box.
22. Repeat
23. Click OK on the Discover Setup dialog box.

Configuring SNMP credentials

1. Select Discover > Setup.
2. Select an IP address from the Available Addresses table.
3. Click Edit.
4. Click the SNMP tab.
DCFM Enterprise User Manual
53-1001775-01
check box.
•
If you selected Configure for 256-Port_Director_Name, go to step 18.
•
If you did not select Configure for 256-Port_Director_Name, continue with step 15.
Address Properties dialog box (SNMP Tab - v3)
•
If you selected Configure for 256-Port_Director_Name, go to step 21.
•
If you did not select Configure for 256-Port_Director_Name, continue with step 19.
If the seed switch is partitioned, the Undiscovered Seed Switches dialog box displays.
a. Select the Select check box for each undiscovered seed switch to discover their fabrics.
b. Click OK on the Undiscovered Seed Switches dialog box.
step 2 through step 21
The Discover Setup dialog box displays.
The Address Properties dialog box displays.
Configuring SNMP credentials
for each fabric you want to discover.
2
39