Brocade Communications Systems Brocade BladeSystem 4/24 User Manual page 463

9. Select the FCoE check box.
10. Select the CEE interface to carry the FCoE traffic from the Selection List and click Add to add it
11. Click OK on the VLAN Configuration dialog box to save your changes.
12. Close Web Tools.
Creating VLAN classifiers and activating on the CEE interface
NOTE
This procedure is completed using the CLI. For more information, see
using Telnet"
To create and activate the VLAN classifiers on the CEE interface, complete the following steps.
1. Log into the switch and enter global configuration mode.
2. Create and apply VLAN Classifiers to the CEE interface to classify Ethernet frames on an
3. Apply the VLAN classifier Group to the CEE interface.
4. Save the running-config file to the startup-config file.
DCFM Enterprise User Manual
53-1001775-01
to the Selected List.
on page 464.
Example
switch:<userid>>cmsh
switch#configure terminal
untagged interface to VLAN.
Example
switch(config)#vlan classifier rule 1 proto fip encap ethv2
switch(config)#vlan classifier rule 2 proto fcoe encap ethv2
switch(config)#vlan classifier group 1 add rule 1
switch(config)#vlan classifier group 1 add rule 2
Example of activating VLAN classifier on the interface Te 0/7
switch(conf-if-te-0/7)#vlan classifier activate group 1 vlan 1002
Example
switch#copy running-config startup-config
Minimum CEE configuration for FCoE traffic
17
"CEE switch management
425