Adding A Pm Threshold Crossed Policy - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

10

Adding a PM threshold crossed policy

6. Define the trigger in the IP Address, Node WWN, and Name list.
7.
8. Enter a value (between 1 and 999) in the Duration field.
9. Select the duration type (Seconds or Minutes) from the Duration list.
10. Select the check box in the Actions list for each action you want to occur when this policy is
11. Click OK on the Add Event Policy dialog box.
12. Select the Active check box for the policy you want to activate.
13. Click OK on the Event Policies dialog box.
Adding a PM threshold crossed policy
To add a PM threshold crossed policy, complete the following steps.
1. Select Monitor > Event Policies.
2. Click Add.
3. Enter a name (1024 characters maximum) for the policy in the Name field.
4. Enter a description (1024 characters maximum) for the policy in the Description field.
5. Select PM Threshold Crossed from the Policy Type list.
6. Define the trigger in the IP Address, Node WWN, and Name list.
7.
8. Enter a value (between 1 and 999) in the Duration field.
260
The trigger is limited to 1024 characters. Multiple values must be separated by a semi-colon.
When multiple values are entered, as long as at least one value matches the IP address, Node
WWN, or Name in the event and all other conditions are met, an action is triggered.
IP addresses can either be in IPv4 or IPv6 format and must be complete.
A Node WWN is accepted with or without the colon.
Enter a value (between 2 and 999) in the Count field.
The maximum duration is 30 minutes.
triggered.
For a list of the available actions, refer to
refer to "Defining the broadcast message action"
action" on page 263, "Defining the send e-mail action"
data capture action" on page 265.
The Event Policies dialog box displays.
The Add Event Policy dialog box displays.
Policy names must be unique; however, they are case insensitive.
The trigger is limited to 1024 characters. Multiple values must be separated by a semi-colon.
When multiple values are entered, as long as at least one value matches the IP address, Node
WWN, or Name in the event and all other conditions are met, an action is triggered.
IP addresses can either be in IPv4 or IPv6 format and must be complete.
A Node WWN is accepted with or without the colon.
Enter a value (between 2 and 999) in the Count field.
"Policy actions" on page 258. To define an action,
on page 262, "Defining the launch script
on page 264, or "Configuring support
DCFM Enterprise User Manual
53-1001775-01