8. Click OK on the Edit Invalid Words Threshold dialog box.
9. Click OK on the Port Fencing dialog box.
Editing a Link threshold
NOTE
This threshold is only available for M-EOS devices.
To edit a Link threshold, complete the following steps.
1. Select Configure > Port Fencing.
2. Select Link from the Violation Type list.
3. Click Edit.
4. Change the name for the threshold in the Name field, if necessary.
5. Change the number of link events allowed for the threshold from the Threshold errors list.
6. Select the time period for the threshold (in minutes) from the errors per list.
7.
8. Click OK on the Port Fencing dialog box.
DCFM Enterprise User Manual
53-1001775-01
If the threshold has already been assigned to ports, an "Are you sure you want to make the
requested changes to this threshold on "X" ports?" message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 339.
The Port Fencing dialog box displays.
The Edit Link Threshold dialog box displays.
FIGURE 136
Edit Link Threshold dialog box
Click OK on the Edit Link Threshold dialog box.
If the threshold has already been assigned to ports, an "Are you sure you want to make the
requested changes to this threshold on "X" ports?" message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 339.
Editing a Link threshold
"Assigning thresholds"
"Assigning thresholds"
13
on
on
343