Enabling A Traffic Isolation Zone; Disabling A Traffic Isolation Zone - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

22

Enabling a traffic isolation zone

Enabling a traffic isolation zone
NOTE
Traffic isolation zones are configurable only on a Fabric OS device.
Use this procedure to enable a traffic isolation zone. When a zone configuration in the same zone
database is activated, the enabled TI zones are also activated at that time. Traffic isolation zones
are enabled by default when you create them.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Right-click the traffic isolation zone you want to enable in the Zones list and select Configured
5. Click OK or Apply to save your changes.

Disabling a traffic isolation zone

NOTE
Traffic isolation zones are configurable only on a Fabric OS device.
Traffic isolation zones are enabled by default when you create them. Use this procedure to disable
a traffic isolation zone. To apply the settings and deactivate the zone, you must activate a zone
configuration in the same zone database.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Right-click the traffic isolation zone you want to disable in the Zones list and clear the
5. Click OK or Apply to save your changes.
636
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
Enabled.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas. The traffic isolation zone is activated when you activate a zone
configuration in the same zone database.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
Configured Enabled check box.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas. The traffic isolation zone is not disabled until you activate a zone
configuration in the same zone database.
DCFM Enterprise User Manual
53-1001775-01