Brocade Communications Systems Brocade BladeSystem 4/24 User Manual page 433

FIGURE 156
11. Click Finish to close the FCIP Tunnel Configuration wizard.
DCFM Enterprise User Manual
53-1001775-01
FCIP Circuit Advanced Settings
-
Select the Selective Ack Off check box to disable or enable selective acknowledgement.
Selective acknowledgement allows a receiver to acknowledge multiple lost packets with a
single ACK response. This results in better performance and faster recovery time.
Normally, selective acknowledgement should not be disabled. Do not disable selective
acknowledgement unless you have a specific need to do so in your operating environment.
-
Use the Keep Alive Time Out (ms) option to override the default value of 10000 ms. As
shown, the range is from 500 to 7200000.
-
Use the Max. Retransmission Time (ms) option to override the default value of 100 ms.
-
Use the Max. Retransmits option to override the default value of 8. As shown, the range is
1 to 8.
-
Select L2CoS and DSCP priorities. Refer to
information.
Adding an FCIP circuit
"QOS, DSCP, and VLANs" on page 386 for more
16
395