Enabling The Encryption Engine State From Properties; Disabling The Encryption Engine State From Properties; Viewing And Editing Group Properties - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual
Supporting dcfm 10.4.x
Hide thumbs
Also See for Brocade BladeSystem 4/24:
- User manual (830 pages) ,
- Command reference manual (894 pages) ,
- Documentation update (271 pages)
Table of Contents
Advertisement
20
Enabling the encryption engine state from Properties
Enabling the encryption engine state from Properties
To enable the encryption engine, complete the following steps.
1. Find the Set State To entry under Encryption Engine Properties.
2. Click the field and select Enabled.
3. Click OK.
Disabling the encryption engine state from Properties
To disable the encryption engine, complete the following steps.
1. Find the Set State To entry under Encryption Engine Properties.
2. Click the field and select Disabled.
3. Click OK.
Viewing and editing group properties
To view encryption group properties, complete the following steps.
1. Select Configure > Encryption.
2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu
3. Select a group from the Encryption Devices table, and select Group > Properties from the
578
The Encryption Center dialog box displays.
bar.
The encryption groups display in the Encryption Devices table.
menu bar, or right-click the group and select Properties.
The Encryption Group Properties dialog box, shown in
defined in this section:
•
"General tab"
on page 579
•
"Members tab"
on page 580
•
"Security tab"
on page 583
•
"HA Clusters tab"
on page 584
•
"Engine Operations tab"
•
"Link Keys tab"
on page 585
•
"Tape Pools tab"
on page 585
NOTE
The Link Keys tab appears only if the key vault type is NetApp LKM.
Figure
on page 584
257, has six tabs which are
DCFM Enterprise User Manual
53-1001775-01
Advertisement
Chapters
Table of Contents
Troubleshooting
