Minimum Cee Configuration For Fcoe Traffic - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

17

Minimum CEE configuration for FCoE traffic

Minimum CEE configuration for FCoE traffic
You must complete the following procedures to create the basic configuration of CEE for FCoE
traffic.
NOTE
The first two procedures in this section can be completed as a single procedure. They were broken
into two separate procedures for clarity.
Creating a CEE map to carry the LAN and SAN traffic
To create a CEE map to carry the LAN and SAN traffic, complete the following steps.
1. Select Configure > Switch > CEE.
2. Select the switch to edit in the CEE Ports and LAGs table and click Edit.
3. Click the QOS tab.
4. Use
5. Click Close on the CEE Configuration dialog box.
422
The CEE Configuration dialog box displays.
The CEE Edit Switch dialog box displays.
The CEE Edit Switch - QoS tab dialog box displays
FIGURE 173 CEE Edit Switch dialog box - QOS tab
"Creating a CEE map"
shown in the dialog box above.
on page 438 to create a new CEE Map to carry the traffic types, as
DCFM Enterprise User Manual
53-1001775-01