Editing A Destination; Removing A Destination; Disabling Trap Forwarding - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

Editing a destination

To edit a destination, complete the following steps.
1. Select Monitor > SNMP Setup.
2. Click the Trap Forwarding tab.
3. Select the destination you want to edit in the Destinations table and click Edit.
4. Click OK on the SNMP Setup dialog box.

Removing a destination

To remove a destination, complete the following steps.
1. Select Monitor > SNMP Setup.
2. Click the Trap Forwarding tab.
3. Select the destination you want to remove in the Destinations table and click Remove.
4. Click OK on the SNMP Setup dialog box.

Disabling trap forwarding

You can disable trap forwarding on all defined destinations.
To disable trap forwarding, complete the following steps.
1. Select Monitor > SNMP Setup.
2. Click the Trap Forwarding tab.
3. Clear the Enable trap forwarding check box.
4. Click OK on the SNMP Setup dialog box.
DCFM Enterprise User Manual
53-1001775-01
The SNMP Setup dialog box displays.
The Add/Edit Trap Recipient dialog box displays.
a. (Optional) In the Description field, edit the description of the trap recipient.
b. In the IP Address field, edit the trap recipient's IP address.
The Management application accepts IP addresses in IPv4 or IPv6 formats.
c. Edit the trap recipient's UDP port number, in the port field.
d. Click OK on the Add/Edit Trap Recipient dialog box.
The SNMP Setup dialog box displays.
Press Ctrl and then click to select more than one destination.
The SNMP Setup dialog box displays.
Editing a destination
10
281