Brocade Communications Systems Brocade BladeSystem 4/24 User Manual page 58

1
Launching the Configuration Wizard
6. Complete the following steps on the Server Configuration screen.
20
b. Select an address from the Switch - Server IP Configuration Preferred Address list.
If DNS is not configured for your network, do not select the 'hostname' option from either
the Server IP Configuration or Switch - Server IP Configuration Preferred Address list.
Selecting the 'hostname' option prevents clients and devices from communicating with
the Server.
If you select a specific IP address from the Server IP Configuration screen and the selected
IP address changes, you will not be able to connect to the server. To change the IP
address, refer to "Configuring an explicit server IP address"
c. Click Next.
NOTE
Do not use port 2638 for any of these port numbers. Port 2638 is used internally by the server.
FIGURE 12
Server Configuration screen
a. Enter a port number in the Syslog Port Number field (default is 514).
NOTE
If the default syslog port number is already in use, you will not receive any syslog
messages from the device.
b. Enable SSL by selecting the SSL Enabled check box.
c. Enter a port number in the Web Server Port Number field (default is 443 if SSL Enabled is
selected; otherwise, the default is 80).
d. Enter a port number in the SNMP Port Number field (default is 162).
e. Enter a port number in the Starting Port Number field (default is 24600).
NOTE
The server requires 16 consecutive free ports beginning with the starting port number.
on page 94.
DCFM Enterprise User Manual
53-1001775-01