Brocade Communications Systems Brocade BladeSystem 4/24 User Manual page 214

7
CIMOM configuration
4. Click Apply.
5. Click Close to close the SMIA Configuration Tool dialog box.
Configuring the Bind Network Address
NOTE
You must have Security Read and Write privileges to make changes on the CIMOM tab.
To configure the network bind address, complete the following steps.
1. Click the CIMOM tab.
2. Select a network address from the IP Configuration Bind Network Address list to which you
3. Click Apply.
4. Click Close to close the SMIA Configuration Tool dialog box.
Configuring the CIMOM log
NOTE
You must have Security Read and Write privileges to make changes on the CIMOM tab.
To configure the CIMOM log, complete the following steps.
1. Click the CIMOM tab.
2. Select a log category from the Log Level list to start logging support data for the server.
176
NOTE
Changes on this tab take effect after the next CIMOM server restart.
If you disabled SSL, a confirmation message displays. Click Yes to continue.
want to bind the CIMOM server.
The default network address is the host system name.
NOTE
Changes on this tab take effect after the next CIMOM server restart.
Options include the following:
•
Off—select to turn off logging support data.
•
Severe—select to only log support data that indicates serious failures which prevent
normal program operation.
•
Warning—select to only log support data that indicates a potential problem.
•
Info (default)—select to only log support data for informational messages.
•
Config—select to only log support data for static configuration messages used to assist in
debugging problems associated with particular configurations.
•
Fine—select to only log message data used to provide trace information.
DCFM Enterprise User Manual
53-1001775-01