Adding A Protocol Error Threshold - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

8. Click OK to add the Link Resets threshold to the table and close the Add Link Reset Threshold
9. Click OK on the Port Fencing dialog box.

Adding a Protocol Error threshold

To add a Protocol Error threshold, complete the following steps.
1. Select Configure > Port Fencing.
2. Select Protocol Error from the Violation Type list.
3. Click Add.
4. Enter a name for the threshold in the Name field.
5. (M-EOS devices only) Select the M-EOS check box.
6. (Fabric OS devices only) Select the Fabric OS check box.
DCFM Enterprise User Manual
53-1001775-01
dialog box.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 339.
The Port Fencing dialog box displays.
The Add Protocol Error Threshold dialog box displays.
FIGURE 130
Add Protocol Error Threshold dialog box
a. Select the number of protocol errors allowed for the threshold from the Threshold errors
list.
b. Select the time period for the threshold (in minutes) from the errors per list.
a. Select one of the following options:
•
Default—Uses device defaults. Go to
•
Custom—Uses your selections. Continue with
b. Enter the number of protocol errors allowed for the threshold from the Threshold errors
field.
Adding a Protocol Error threshold
"Assigning thresholds"
step 7.
step b.
13
on
335