10
Enabling SNMP informs
Enabling SNMP informs
NOTE
SNMP Informs is only supported on Fabric OS 6.3 or later switches discovered through SNMP v3. For
information about discovery through SNMP v3, refer to
You can enable SNMP informs on all Informs-capable Fabric OS switches.
To enable Informs, complete the following steps.
1. Select Monitor > SNMP Setup.
2. Click the Informs tab.
3. Select the Enable informs option.
4. Select the fabric on which you want to enable Informs from the Fabric list.
5. Click OK on the SNMP Setup dialog box.
Disabling SNMP informs
To disable Informs, complete the following steps.
1. Select Monitor > SNMP Setup.
2. Click the Informs tab.
3. Select the Disable informs option.
4. Select the fabric on which you want to disable Informs from the Fabric list.
5. Click OK on the SNMP Setup dialog box.
282
The SNMP Setup dialog box displays.
NOTE
If you want to enable Informs only on specific switches in a Fabric, you must configure Informs
using the Element Manager on each switch or through the command line interface.
All Informs-capable switches display in the SNMP Informs Capable Switch in the Fabric table.
SNMP Informs will be enabled on all switches in the SNMP Informs Capable Switch in the
Fabric table.
The SNMP Setup dialog box displays.
All Informs-capable switches display in the SNMP Informs Capable Switch in the Fabric table.
SNMP Informs will be disabled on all switches in the SNMP Informs Capable Switch in the
Fabric table.
"Discovering fabrics"
on page 36.
DCFM Enterprise User Manual
53-1001775-01