Removing Ports From A Logical Switch - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

Removing ports from a logical switch

1. Select a switch on the Product List or Connectivity Map and select Configure > Logical
2. Select the physical chassis to which the ports belong in the Chassis list.
3. Right-click anywhere in the Existing Logical Switches table and select Table > Expand All.
4. Select the ports you want to remove from the logical switches from the Existing Logical
5. Click the left arrow button.
6. Click OK on the DCFM Warning message.
7.
8. Click OK on the Logical Switches dialog box.
9. Select the Re-Enable ports after moving them check box.
10. (Optional) Select the Unbind Port Addresses while moving them check box.
11. Click Start to send these changes to the affected chassis.
12. When the changes are complete, click Close.
DCFM Enterprise User Manual
53-1001775-01
Switches.
The Logical Switches dialog box displays.
Switches table.
A message displays indicating that the ports will be moved to the default logical switch.
The selected ports are removed from the logical switch and automatically reassigned to the
default logical switch. The selected ports are highlighted in the Ports table.
(Optional) Perform the following steps to assign the ports to a logical switch other than the
default logical switch:
a. Select the destination logical switch in the Existing Logical Switches table.
b. Click the right arrow button.
The ports display in the selected logical switch node in the Existing Logical Switches table.
The Logical Switch Change Confirmation and Status dialog box displays with a list of all
changes you made in the Logical Switches dialog box.
NOTE
Ports are disabled before moving from one logical switch to another.
NOTE
Most changes to logical switches will disrupt data traffic in the fabric.
The status of each change is displayed in the Status column and Status area in the dialog box.
Removing ports from a logical switch
21
597