Brocade Communications Systems Brocade BladeSystem 4/24 User Manual page 430

16
Configuring an FCIP tunnel
3. Click the Add Tunnel button, or right-click on the switch and select Add Tunnel.
FIGURE 154
4. Click Select Switch Two under Switch Two Settings to display discovered extension switches,
5. Enter a description of the tunnel in the Description field.
6. Select Add Circuit.
392
The Add FCIP Tunnel dialog is displayed
displayed in the Switch field under Switch One Settings. This dialog allows you to configure
settings for both switches on either end of the tunnel.
Add FCIP Tunnel dialog box
and select the switch that you want to connect to switch one.
The switch name and fabric are displayed in the Switch and Fabric fields.
NOTE
You cannot assign a Tunnel ID until after at least one circuit is configured. The Add Circuit
dialog returns you to the Add FCIP Tunnel dialog to allow you to select the Tunnel ID.
The Add FCIP Circuit dialog is displayed. Continue with
(Figure 154). The name of the switch you selected is
"Adding an FCIP circuit".
DCFM Enterprise User Manual
53-1001775-01