Adding A State Change Threshold - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

13

Adding a State Change threshold

7.
8. Click OK on the Port Fencing dialog box.
Adding a State Change threshold
NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
To add an State Change threshold, complete the following steps.
1. Select Configure > Port Fencing.
336
c. Select the time period for the threshold from the errors per list. The following choices are
available:
•
None—the port is blocked as soon as the specified number of protocol errors allowed
is met.
•
Second—the port is blocked as soon as the specified number of protocol errors
allowed is reached within a second.
•
Minute—the port is blocked as soon as the specified number of protocol errors allowed
is reached within a minute.
•
Hour—the port is blocked as soon as the specified number of protocol errors allowed is
reached within a hour.
•
Day—the port is blocked as soon as the specified number of protocol errors allowed is
reached within a day.
Click OK to add the protocol errors threshold to the table and close the Add Protocol Error
Threshold dialog box.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 339.
The Port Fencing dialog box displays
FIGURE 131
Port Fencing dialog box
(Figure 124).
"Assigning thresholds" on
DCFM Enterprise User Manual
53-1001775-01