Dell PowerConnect W-7200 Series Reference Manual page 1242

RSSI Check Frequency
The output of this command includes the following parameters:
Parameter
Station Handoff
Assist
Detect Association
Failure
Coverage Hole
Detection
Hole Good RSSI
Threshold
Hole Good Station
Ageout
Hole Detection
Interval
Hole Idle Station
Ageout
Hole Poor RSSI
Threshold
Detect interference
Interference
Threshold
Interference
Threshold Exceed
Time
Interference
Baseline Time
RSSI Falloff Wait
Time
Low RSSI Threshold
RSSI Check
Frequency
Command History
Version
ArubaOS 3.0
ArubaOS 3.4
1242 | show rf optimization-profile
0 sec
Description
If enabled, this parameter allows the controller to force a client off an AP when the RSSI
drops below a defined minimum threshold.
Shows if the profile enables or disables STA association failure detection.
Shows if the profile enables or disables coverage hole detection.
Time, in seconds, after a coverage hole is detected until a coverage hole event notification is
generated.
This parameter requires the RF Protect license.
Stations with signal strength above this value are considered to have good coverage.
This parameter requires the RF Protect license.
Time, in seconds, after which a station with good coverage is aged out.
This parameter requires the RF Protect license.
Time, in seconds, after which a station in a poor coverage area is aged out.
This parameter requires the RF Protect license.
Stations with signal strength below this value will trigger detection of a coverage hole.
This parameter requires the RF Protect license.
Enables or disables interference detection.
Percentage increase in the frame retry rate (FRR) or frame receive error rate (FRER) before
interference monitoring begins on a given channel.
Time, in seconds, the FRR or FRER exceeds the threshold before interference is reported.
Time, in seconds, the air monitor should learn the state of the link between the AP and client
to create frame retry rate (FRR) and frame receive error rate (FRER) baselines.
Time, in seconds, to wait with decreasing RSSI before a deauthorization message is sent to
the client. The maximum value is 8 seconds.
Minimum RSSI above which deauthorization messages should never be sent.
Interval, in seconds, to sample RSSI.
Modification
Base operating system
Output parameters displaying load balancing status were removed. You can now view
the status of the load balancing feature via the commands
and show rf dot11g-radio-profile.
show rf dot11a-radio-profile
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide