Network - D-Link DGS-6600-48TS Manual

DGS-6604 m

network

network NETWORK-PREFIX / MASK
no network NETWORK-PREFIX / MASK
Syntax Description
NETWORK-PREFIX /
MASK
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# router rip
Switch(config-router)# network 192.168.70.0/24
Swtich(config-router)# network 10.99.0.0/16
Switch(config-router)# end
CLI Reference Guide
Use the command to specify that the network utilizes Routing Information
Protocol (RIP). To remove an RIP network entry, use the no form of this
command.
The network prefix and the prefix length specify the destination network in the
form of xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx or xxx.xxx.xxx.xxx/x.
Example: 10.9.18.2 255.0.0.0 or 10.9.18.2/8
Not configured
Router configuration
Use this command to specify networks to which routing updates are sent and
received. If a network is not specified, the interfaces in that network will not be
advertised in any RIP update.
The following example shows how to define RIP as the routing protocol to be
used on all interfaces connected to networks 192.168.70.0/24 and network
10.99.0.0/16
Verify the settings by entering the show ip protocols rip command.
network
459