Hybrid Vlan Vlan-Id - D-Link DGS-6600-48TS Manual

DGS-6604

hybrid vlan VLAN-ID

hybrid vlan VLAN-ID [ , | - ] {tagged | untagged}
no hybrid vlan [VLAN-ID [ , | - ] ]
Syntax Description
VLAN-ID
tagged
untagged
,
-
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth3.1
Switch(config-if)# hybrid vlan 1000 tagged
CLI Reference Guide
Use the hybrid VLAN command to set the VLAN characteristic. It sets the
interface as a tagged member or un-tagged member.
Specifies the VLAN to add or remove tagging member from it.
Specifies the port as a tagged member of specified VLAN(s).
Specifies the port as an untagged member of specified VLAN(s).
(Optional) Specifies a series of VLANs, or separate a range of VLANs from a
previous range. Enter a space before and after the comma.
(Optional) Specifies a range of VLANs. Enter a space before and after the
hyphen.
The default hybrid-vlan is empty.
Interface configuration
Physical ports or port-channels are valid interfaces for this command.
By setting the hybrid VLAN command multiple times, a port can be a tagged
member port or an untagged member port of multiple VLANs.
If the VLAN does not exist, an error message is returned.
When this command is applied, the port will change to hybrid mode. If the mode
is changed, the setting for the previous mode will disappear.
If a VLAN has already been defined as a tagged VLAN, applying this command
in un-tagged VLAN mode will remove that membership.
If a VLAN has already been defined as a un-tagged VLAN, applying this
command in tagged VLAN mode will remove that membership.
When using the no hybrid vlan command without specifying a VLAN ID, then
the port's membership will be removed from all VLANs.
This example shows how to set an interface port 3.1 as a tagged member of
VLAN 1000.
Verify the settings by entering the show vlan command.
hybrid vlan VLAN-ID
218