Gvrp (Interface) - D-Link DGS-6600-48TS Manual

DGS-6604 m

gvrp (Interface)

gvrp
no gvrp
Syntax
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth3.1
Switch(config-if)# gvrp
CLI Reference Guide
Use the gvrp interface command to enable GVRP function for a port, and use
the no gvrp command to disable the GVRP function for a port.
None
Disabled
Interface configuration
Use the gvrp interface configuration command to enable/disable the GVRP
protocol state.
Both physical port and port-channel interfaces are valid for this command. If a
physical port is member of a port-channel, then this command should return an
error message to indicate it.
The GVRP function cannot be enabled when the interface is at access mode.
This example shows how to enable Ethernet eth3.1 GVRP protocol state.
Verify the settings by entering the show gvrp configuration interface
command.
gvrp (Interface)
210